|
|
Item Posts
Sort Order
|
|
|
Transmissions swappable?
|
Skitch9
New User
| Posts: 3
| Joined: 09/03
Posted: 09/09/03
01:13 PM
|
|
I have a project '83 CJ5 with the 258, T-5, and Dana 300. I've made a few modifications to the vehicle, which has cause some difficulty with the rear driveshaft. The drivshaft is short ("16) at a pretty steep angle.
I recently picked up an old International driveline; I'm not sure, but I think it used to be a scout (it had approx "100 wheelbase). It's a (seized) straight six ("power thrift six") with a cast iron three speed and a Dana 18.
Would the three speed bolt up to the CJ engine? It's shorter and would give me a longer drive shaft.
would it be possible to put the T-5s shorter bellhousing and input shaft on the three speed to make it even shorter?
I'm on a bit of a budget, and I'm probably just grasping now, but I really need to do something with this to get it on the trail.
|
|
|
|
AJCHVYK20
New User
| Posts: 26
| Joined: 09/03
Posted: 09/26/03
11:36 PM
|
|
the best place i found to find out what will fit anything is ADVANCED ADAPTERS they should be able to tell you something
|
|
|
|
|
|
|
|
|