she pops out of reverse

i hope someone can help?

my wrangler has a 2" body lift along with 33" bfg all terrian

the problem is that she likes to pop out of reverse.

just hope that it's a linkage prob an not internal probs.

any help would be alot of help.

make sure nothing is touching your shifter

it could be your body is moving or maybe it isnt and your engine- trans is moving... i bet it only pops out when your on the gas right?

   yup, if i give her a little to much gas an she starts to torque up,pop she goes not to mention a lil grind.  

look at the stick... put your hand on it and see if its a hard bump or a softer one. look for things that hit it, body would be the first guess for me.

   was told that it might not have the extender for the shifter. pulled the shift boot up an put it in reverse,looks like it's hitting the body. guess i could cut back the body more?  

cut the body a bit back. not too much.

if i were you i would just beat it back in that one spot with a hammer and chisle.

or for a true rigging.. put it in first and push the shifter forward more to bend it. heating it up would also help.

BUT before you do anything look at your stick and body if it moves a lot.. more than an inch i would check the motor and tranny mounts. its common for them to *** out on you.

good luck one of my answers will help you

as it turns out it was the body getting in the way,had a garage look at it(one that deals with lifted jeeps) took about an hour of trimming an voi la i have reverse back.also had to do some work on shift boot(was binding up on shifter) thanks for the help,SO MUCH !! happier now.  

how much was that?

body triming? smack it with the heavy tool a few times it would have taken 30 seconds. o well its done and done right i guess