|
Num Posts
Sort Order
|
lil383
New User
| Posts: 1
| Joined: 08/04
Posted: 08/09/04
07:36 AM
|
|
Does anybody have a diagram that shows the correct installation order of the pressure regulator valve on a 700R4 Transmission?
|
quyonmob
Enthusiast
| Posts: 584
| Joined: 11/03
Posted: 08/10/04
10:05 AM
|
|
check on the B&M website for shift kit instructions. when i put in my shift kit, there were excellent instructions for re-assembly.
Goodluck
|
fixxer
New User
| Posts: 20
| Joined: 08/04
Posted: 09/05/04
05:33 AM
|
|
Try this
   Step 19: IMPORTANT: Check the second land on the pressure regulator valve to make sure that there are either flat spots ground into the land, or that the second land has been completely ground off. If the second land on your pressure regulator valve is unmodified, grind two flat spots into the land as shown. Use a wire-wheel to remove any grinding burrs from the valve, then thoroughly clean the valve. Slide the pressure regulator valve and pressure regulator valve spring into the pressure regulator bore. Make sure that the valve slides freely all the way to the bottom of the bore.
|
|
|