|
Num Posts
Sort Order
|
|
Posted: 09/15/08
05:53 PM
|
|
was curious if i can take an aluminum intake manifold for small block chevy of the 80's era, widen the 4 center holes so the bolts will drop straight through and put it on a late 80's early 90's small block throttle body engine.
|
mudb8_
Moderator
| Posts: 315
| Joined: 11/07
Posted: 09/15/08
06:50 PM
|
|
some have done it, they are actually drilled at a different angle...
Help save TELLICO...VIRTUAL RALLY for Tellico...
http://www.pirate4x4.com/forum/showthread.php?p=8149649#post8149649
The rally will be on Wednesday May 7th from 4 to 9 pm Eastern Standard Time.
Be there and post up POSITIVE COMMENTS!!
|
|
Posted: 09/16/08
07:26 AM
|
|
THAT IS A VERY RISKY JOB TO ATTEMPT, BUT IT IS POSSIBLE. JUST MAKE SURE THAT YOU HAVE THE HOLE DRILLED SO THAT YOUR BOLTS WILL SIT TIGHT. YOU DO NOT WANT TO DRILL IT LOOSE BECAUSE YOU MAY LOSE YOUR BLOCK.
|
|
|